Fast Pace Racing

Welcome to the finest indoor RC racing shop in the Bay Area!  Our track is currently the largest at over 900 sq. ft!  Aside from our vast selection of Mini-Z replacement and performance parts (PN, Atomic, Kyosho -- to name a few!), we also carry E-flite helis and parts, and the new MicroCrawler from Losi.  Our customer service is unparalleled in our industry.  You will leave our shop knowing you were completely taken care of -- that's the FPR promise.  Swing by and race your Mini-Z, Xmod, Iwaver, and other on-road 1/24th- 1/28th scale R/C today!

 

2010 KO GP II: MR03 Mod setup

TJ's picture
Posted Wed, 04/28/2010 - 11:24am by TJ

Here's my MR03 Mod car setup I used for the recent KO Propo Grand Prix II event.


Front:
PN 0 degree upper arm
PN 2x4 washer (below the spring)
PN .50mm blue shim (under the knuckle)
PN .50 blue shim (for + caster)
PN MR02 purple (regular height springs)
Atomic Front brace
Atomic MR02 spring cup/limiter
Atomic MR02 spring cup spacer (white)
Atomic blue shim .20mm (on top of the spring)
Atomic .10mm shim under the knuckle
Atomic aluminum NSX front body clip
Atomic Ceramic wheel bearings
Atomic Front dish 0 offset wheel
Kyosho stock knuckles
Kyosho stock upper arm pin/screw
Reflex Racing kingpin (polished)
FPR front wheel spacer

Rear:
PN 94-98mm motor mount/pod v3 (#1 cup right side up)
PN Tri Damper System suspension
PN Red spring for side damper (no preload)
PN titanium screws for TDS and pod
PN Disc Damper System spacer/shock mount
PN Ultra Light Weight Differential Shaft
PN 64 pitch 53T (black spur used w/ 10 balls)
PN 64 pitch 10T pinion
PN +1 Rear Delrin Wheels
PN orange shim on top TDS
PN titanium screws
Kyosho 20 Rear Radials (glued)
Kyosho center shock (60wt oil)
Kyosho side damper grease (15k wt)
Kyosho center shock stock spring (stroke fitted for 96mm: click here for how-to)
Atomic Ceramic wheel & shaft bearings
ACER thrust bearing
QteQ diff hub assembly
Tamiya/O'kami 2mm nut for TDS
TSM 30T motor tuned by Lawrence McCabe III aka LL3 (hand wound & spiral arm. 10k RPM more than my RCX motor)
TRP900/ RP900 (professionally matched w/ TurboMatcher-8)
Reflex Racing Ceramic Balls
Reflex Racing 96mm T-bar (soft)

Others:
2.3mm Ride Height F/R
ICS Setting default w/ #3 Inertia
Futaba 3PKS radio
2007 NSX body trimmed to fit 96-98mm painted by Joey Ellis
Car weighed in at 182-185 grams
2x3 8858 FETS by Doug Graham

Sponsors:
Peter and Dee Dinh of Fast Pace Racing
Roger Serafin of RS Graphix
LL3/TSM motors
Ray Leung of HKT&D for my custom parts when needed. ;)

Thanks for looking!

-Tj Macabuhay